01 / Design
Every job starts with drawings: load calculations, cable sizes, protection and layout. You get the full set at handover, so anyone can maintain or extend the system later.
Without drawings, nobody knows what's inside your walls. We design every circuit first: load calculations, cable sizing, protection and layout.
Because the design is documented, a solar plant, EV charger or automation can be added to a known system.
We walk the site, list every load you have and every load you intend to add, and build a demand assessment with diversity factors applied, not a rule-of-thumb multiplier.
Conductor sizing against current capacity, voltage drop and short-circuit withstand. Protective devices selected and coordinated so the nearest device trips first, and earthing designed rather than assumed.
2D layout sketches, single-line diagrams, panel schedules and cable routing, coordinated with your architect and civil contractor before anyone cuts a chase.
You approve the design before work starts, and receive the full set at handover. Supervision of the installation is available under a KSEB Supervisor License held in-house.
Where It Applies
The cheapest time to design an electrical system is before the walls close. Points, circuits, load centres and provision for future solar, EV charging and automation, fixed on paper while changes still cost nothing.
Three-phase distribution, metering, load balancing and protection coordination for shops, offices and showrooms, designed around your actual operating hours and connected load.
Buildings that have been extended circuit by circuit for twenty years. We survey what is actually there, document it, and design a safe replacement you can maintain.
Adding generation or IoT control to an undocumented system is where budgets go wrong. Design the electrical layer first and the rest bolts onto a known system.
Common Questions
An electrician installs; a design decides what should be installed. The design is what tells you the cable size is right for the run, that the protection will actually trip, and what is behind the wall in ten years. Many of our clients bring their own contractor and use us for the design and supervision.
A load study and demand assessment, 2D electrical layout drawings, single-line diagrams, panel schedules, cable routing and earthing details, plus the documentation set for future maintenance. It is yours to keep and to hand to any future contractor.
Yes. Coordination with architects and civil contractors is part of the package. Getting the electrical design into the drawing set early is what prevents conduit clashes and last-minute chasing of finished walls.
Yes. A Kerala State Electricity Licensing Board Supervisor License is held on our founding team: the statutory qualification for supervising electrical installation work in the state.
If you tell us it is coming, yes. We provision the load centre, spare ways and cable routes at design stage, which is dramatically cheaper than retrofitting them later.
Tel 0484-2684066 · Mail [email protected]
